vendredi 1 juillet 2016

article technique Custom Rodder : fabriquer son parechoc (7)


The top and bottom sections look like this after the seam is welded.

Marcel then grinds the welds to create a peak that runs the length of the bumper.

Once the center section and corners are made, they get clamped together over the old bumper. All sections are intentionally made a little too long or too wide, so Marc uses a scribe to show where cuts need to be made to fit the pieces together.

Marc trims the excess metal off each piece using hand shears.


Aucun commentaire:

Enregistrer un commentaire